W-001-A
WARNING!
Before normal operation of the
shower, it is essential the following
commissioning procedure is completed
correctly.
To start the shower
Pressing the START/STOP button (fig.22)
switches on the pump allowing water to
immediately flow through the unit.
To stop the shower
Press the START/STOP button. This switches off
the pump and the water flow will cease.
W-003-A
WARNING!
If restarting immediately after
stopping, be aware that a slug of hot
water will be expelled for the first few
seconds.
To use the power selector
The power selector (fig.22) has four settings
— COLD, LOW, MEDIUM and FULL POWER.
Blue symbol is for COLD water only. Adjusting
the temperature control at this setting will only
increase or decrease the force of the water
from the showerhead. It will not alter the water
temperature.
Red outline symbol is the LOW setting for extra
economy during hot months. Temperature
adjustment at this setting is via the temperature
control.
Single red symbol is the MEDIUM setting for
economy during warmer months and any
temperature adjustment at this setting is via the
temperature control.
Double red symbol is FULL power setting which
allows the highest flow achievable for your
preferred temperature. Temperature adjustment
at this setting is via the temperature control.
Note: In normal use, it is in order to leave the
water supply permanently on to the shower
unit, but as with most electrical appliances,
the unit must be switched off at the
isolating switch when not in use.
Operating the shower
To Next Page
Loading...
Need help?
General
