17
T90xr pumped electric shower
To adjust the shower temperature
The shower temperature is altered by increasing
or decreasing the flow rate of the water through
the shower via the temperature control.
After obtaining your preferred shower
temperature, the number can be remembered as
the normal setting and should only need to be
altered to compensate for seasonal changes in
ambient water temperatures.
To decrease the shower temperature
Turn the temperature control anti-clockwise
towards the lower numbers; this will increase the
water flow.
To increase the shower temperature
Turn the temperature control clockwise towards
the higher numbers; this will decrease the water
flow.
Note: It is advisable to be certain that the
showering temperature is satisfactory by testing
with your hand before stepping under the
showerhead.
There will always be a time delay of a few
seconds between selecting a flow rate and the
water reaching the stable temperature for that
flow rate.
CAUTION: It is recommended that persons
who may have difficulty understanding or
operating the shower controls should not
be left unattended while showering. Special
consideration should be given to young
children and the less able bodied.
W-002-A
WARNING!
After any servicing of mains water
supply, always flush out the pipework
to remove any debris.
Always make sure the unit is started
on COLD in order to purge any air in
the pipework.
WARNING!
This appliance is not intended for use
by persons (including children) with
reduced physical, sensory or mental
capabilities, or lack of experience
and knowledge, unless they have
been given supervision or instruction
concerning use of the appliance by a
person responsible for their safety.
Children should be supervised to
ensure that they do not play
with the appliance.
To Next Page
Loading...
Need help?
General
