MAINTENANCE
110
Engine Oil
In order for the engine, transmission,
and clutch to function correctly,
maintain the engine oil at the correct
level, and change the engine oil and oil
filter in accordance with scheduled
maintenance requirements.
Engine Oil Level Inspection
DANGER
Never start the engine or run the
engine in a confined area.
Always operate the motorcycle in the
open air or in an area with adequate
ventilation.
Exhaust fumes are poisonous and will
cause loss of consciousness and death
within a short period of time.
CAUTION
If the engine has recently been
running, the exhaust components may
be hot to the touch.
To avoid skin damage, always allow the
hot parts to cool before touching the
exhaust system.
Contact with the hot components may
cause minor or moderate injury to
exposed skin.
NOTICE
Make sure no contamination enters
the engine during an engine oil
change or top up.
Contamination entering the engine
may lead to engine damage.
NOTICE
If the engine oil pressure is too low,
the low oil pressure warning light will
illuminate.
If the low oil pressure indicator
remains on, stop the engine
immediately and investigate the
situation.
Running the engine with low oil
pressure will cause severe engine
damage.
1. Filler plug
2. Sight glass
3. Maximum limit
4. Minimum limit
To inspect the engine oil level:
▼ Start the engine and run at idle for
approximately five minutes. Stop the
engine and wait for at least three
minutes to allow the engine oil to
settle.
▼ Note the engine oil level visible in the
sight glass.
To Next Page
Loading...
Need help?
General
