MAINTENANCE
129
Disc Brake Fluid
WARNING
Brake fluid is hygroscopic which
means it will absorb moisture from the
air.
Any absorbed moisture will greatly
reduce the boiling point of the brake
fluid causing a reduction in braking
efficiency.
Because of this, always replace brake
fluid in accordance with scheduled
maintenance requirements.
Always use new brake fluid from a
sealed container and never use fluid
from an unsealed container or from
one which has been previously
opened.
Do not mix different brands or grades
of brake fluid.
Check for fluid leakage around brake
fittings, seals and joints and also
check the brake hoses for splits,
deterioration and damage.
Always rectify any faults before riding.
Failure to follow the advice above may
lead to loss of motorcycle control
which could result in serious injury or
death.
WARNING
If the Anti-lock Brake System (ABS) is
not functioning, the brake system will
continue to function as a non-ABS
equipped brake system. Reduce speed
and do not continue to ride for longer
than is necessary with the ABS
warning light illuminated.
The fault must be checked and
rectified by a competent person with
the specialist knowledge and technical
understanding of motorcycles, such as
an authorised Triumph dealer.
Braking too hard will cause the wheels
to lock, leading to loss of motorcycle
control which could result in serious
injury or death.
Inspect the level of brake fluid in both
reservoirs and change the brake fluid in
accordance with scheduled
maintenance requirements. Use Triumph
Performance DOT 4 brake fluid as
recommended in the Specification
section. The brake fluid must also be
changed if it becomes, or is suspected
of having become contaminated with
moisture or any other contaminants.
NOTICE
A special tool is required to bleed the
braking system. When the brake fluid
needs renewing or the hydraulic
system requires maintenance, contact
a competent person with the specialist
knowledge and technical
understanding of motorcycles, such as
an authorised Triumph dealer.
To Next Page
Loading...
Need help?
General
