GENERAL INFORMATION
58
When the motorcycle is delivered from
the factory, two ignition keys are
supplied together with a small tag
bearing the key number. Make a note of
the key number and store the spare key
and key number tag in a safe place
away from the motorcycle.
A transponder is fitted within the
ignition keys to turn off the engine
immobiliser. To make sure the
immobiliser functions correctly, always
have only one of the ignition keys near
the ignition switch. Having two ignition
keys near the switch may interrupt the
signal between the transponder and the
engine immobiliser. In this situation the
engine immobiliser will remain active
until one of the ignition keys is removed.
Always get replacement keys from your
authorised Triumph dealer. Replacement
keys must be 'paired' with the
motorcycle’s immobiliser by your
authorised Triumph dealer.
Engine Immobiliser
The ignition switch housing acts as the
antenna for the engine immobiliser.
When the ignition switch is turned to
the OFF position and the ignition key is
removed, the engine immobiliser is on
(see page 37). The engine immobiliser is
turned off when the ignition key is in
the ignition switch and it is turned to
the ON position.
Brake Lever Adjusters
WARNING
Do not attempt to adjust the levers
with the motorcycle in motion as this
could lead to loss of motorcycle
control.
After adjusting the levers, operate the
motorcycle in an area free from traffic
to gain familiarity with the new lever
setting.
Do not loan your motorcycle to
anyone as they may change the lever
setting from the one you are familiar
leading to loss of motorcycle control
which could result in serious injury or
death.
An adjuster is fitted to the front brake
lever. The adjuster allows the distance
from the handlebar to the brake lever to
be changed to suit the span of the
rider's hands.
Speed Twin 1200 and Thruxton RS Only
1. Brake lever
2. Adjusting screw
To Next Page
Loading...
Need help?
General
