MAINTENANCE
135
Scrambler 900
1. Upper level line
2. Lower level line
To inspect the rear brake fluid level:
▼ Remove the right hand side panel as
described for the Scrambler 900 on
page77.
▼ The brake fluid level in the rear
reservoir must be kept between the
upper and lower level lines.
To adjust the rear brake fluid level:
▼ Release the reservoir from the frame
without detaching the connecting
hose.
▼ Remove the reservoir cap noting the
position of the sealing diaphragm.
▼ Fill the reservoir to the upper level
line using new DOT 4 brake fluid from
a sealed container.
▼ Refit the reservoir cap making sure
that the diaphragm seal is correctly
positioned between the reservoir cap
and the reservoir body.
▼ Refit the reservoir to the frame by
tightening the original fixing to 5 Nm.
▼ Refit the right hand side panel.
Brake Light Switches
WARNING
Riding the motorcycle with defective
brake lights is illegal and dangerous.
Before riding the motorcycle, make
sure all lights are working.
Failure to follow the advice above
could result in serious injury or death.
The brake light is activated
independently by either the front or
rear brake. If, with the ignition in the ON
position, the brake light does not work
when the front brake lever is pulled or
the rear brake pedal is pressed, the
fault must be checked and rectified by a
competent person with the specialist
knowledge and technical understanding
of motorcycles, such as an authorised
Triumph dealer.
To Next Page
Loading...
Need help?
General
