MAINTENANCE
126
Final Drive Chain Guard -
Installation
WARNING
Make sure the motorcycle is stabilised
and adequately supported.
Do not support the motorcycle on any
ancillary component, the exhaust
system or any other non structural
parts of the motorcycle frame.
A correctly supported motorcycle will
help prevent it from falling.
An unstable motorcycle may fall
resulting in motorcycle damage,
serious injury or death.
▼ For all models except Speed Twin
only: Fit the chain guard and tighten
the fixings to 9 Nm.
▼ For Speed Twin only: Fit the chain
guard and tighten the new front
fixing to 6 Nm, Tighten the rear
fixing to 9 Nm.
1. Fixings
2. Chain guard (Bonneville T120 shown)
Brakes
WARNING
To prevent risk of injury from the
motorcycle falling during the
inspection, make sure that the
motorcycle is stabilised and secured
on a suitable support.
Do not exert extreme force against
each wheel or rock each wheel
vigorously as this may cause the
motorcycle to become unstable and
fall from its support.
Failure to follow the advice above
could result in motorcycle damage,
serious injury or death.
WARNING
Brake pads must always be replaced
as a wheel set. At the front, where two
calipers are fitted on the same wheel,
replace all the brake pads in both
calipers.
After replacement brake pads have
been fitted, ride with extreme caution
until the new pads have 'broken in'.
Replacing individual pads will reduce
braking efficiency and may lead to loss
of motorcycle control which could
result in serious injury or death.
To Next Page
Loading...
Need help?
General
