Triumph Speed Triple R User Manual

Maintenance and Adjustment
123
Battery Removal
Raise and support the fuel tank (see
page 97).
1. Battery
2. Battery strap
3. Negative (black) terminal
4. Positive (red) terminal
Remove the battery strap.
Disconnect the battery leads, negative
(black) lead first.
Take the battery out of the case.
Battery Disposal
Should the battery ever require
replacement, the original battery must
be handed to a recycling agent who will
make sure that the dangerous
substances from which the battery is
manufactured do not pollute the
environment.
Battery Maintenance
Clean the battery using a clean, dry
cloth. Be sure that the cable
connections are clean.
The battery is a sealed type and does
not require any maintenance other than
checking the Voltage and routine
recharging when required, such as
during storage.
It is not possible to adjust the battery
acid level in the battery; the sealing strip
must not be removed.
Warning
Make sure that the battery terminals
do not touch the motorcycle frame as
this may cause a short circuit or
spark, which would ignite battery
gases causing a risk of personal
injury.
2
cgfg
1
3
4
Warning
The battery acid is corrosive and
poisonous and will cause damage to
unprotected skin. Never swallow
battery acid or allow it to come into
contact with the skin. To prevent
injury, always wear eye and skin
protection when handling the battery.

Triumph Speed Triple R Specifications

General

Engine Capacity	1050 cc
Transmission	6-speed
Seat Height	825 mm
Fuel System	Multipoint sequential electronic fuel injection
Engine Type	Liquid-cooled, 12-valve, inline 3-cylinder
Power	148 hp (110 kW) @ 10, 500 rpm
Torque	117 Nm at 7, 150 rpm
Front Suspension	Öhlins 43mm NIX30 upside down forks with adjustable preload, rebound and compression damping
Rear Suspension	Öhlins TTX36 monoshock, fully adjustable
Front Brakes	Twin 320mm floating discs, Brembo 4-piston radial calipers
Fuel Tank Capacity	15.5 litres