Trojan CONCEPT 200 - How to Assemble the Pulleys; How to Assemble the Wires Cable

11485-10
ASSEMBLY STEPS
STEP 05
5.1 How to assemble the Pulleys
s#ONNECTALLFOURTEEN0ULLEYSONTOTHEWELDED0ULLEY"RACKETSLTWO0ULLEY#ONNECTING0LATESANDONE
Floating Pulley Bracket (16).
s3ECURETHEMWITHFOURTEENvXLv"OLTSTWENTYEIGHTvXLMM7ASHERANDFOURTEENv.UTS
(63).
5.2 How to assemble the wires cable
Cable 36 (3305mm)
s 3TARTINGATPULLEYTHREADTHECABLEAROUNDPULLEYTHENFOLLOWTHE!22/73AROUNDNOAND
s &INALLYLETTHEFRONTTHREADEDBOLTOFCABLEGOTHROUGHTHE"LACK&IXING7ASHERTHENTHREADITINTOTHEHEADOF
the Selector Bar (32) to lock together.
s 5SE3NAP(OOKTOCONNECTCABLEAND4OP,AT"ARTOGETHER
Cable 35 (3930mm)
s 3TARTAT0ULLEY.OTHREADTHECABLEAROUNDPULLEYTHENFOLLOWTHE!22/73AROUND.OAND))
s 5SE3NAP(OOKTOCONNECTTOEYEENDOFTHECABLE/.,%'"%!-AND,OWER,AT"ARTOGETHER
s 5SE3NAP(OOKTOCONNECTTOTHEOTHERSIDEOFCABLETOJOINTOGETHER#HAIN3NAP(OOKAND
Ankle Strap (41).
Cable 37(2160mm)
s 3TARTAT.OANDATTACHCABLEON2IGHT"UTTERmY!RMSECURINGITWITHONE"OLTvXLvLONEvWO
Nylon Nut (76), one 3/8’ x l9mm Washer (66) and one 3/8” Nut (63).
s !TTACHTHECABLElRSTTHENASSEMBLETHEPULLEYON.OTHENFOLLOWTHE!22/73TOGOAROUND.OUPTO.O
s !TTACHCABLEON,EFT"UTTERmY!RMSECURINGWITHONEvXv"OLTSONEvWO.YLON.UTL 
one 3/8” x 19mm Washer (66) and one 3/8” Nut(63).
Please make sure all pulleys can turn and cable are tight enough.
PS: Please adjust the original two Pulley Connecting Plates (l7) at “A” hole and tighten the
threaded bolt of cable 36 to
Selector Bar (32) if the cables are not tight enough during workout.