Trojan CONCEPT 200 - Assembly Steps; Assembly of the Base Frame and Weight Stack

11485-6
4. ASSEMBLY STEPS
STEP 01 Assembly of the base frame and weight stack
s  *OIN44UBEAND(ORIZONTAL"EAMSECURINGTHEMWITHTWOvXv"OLTSFOURvXMM 
Washer (66) and two 3/8” Nut (63).
Note: Two 3/8”x19mm Washer (66) and two 3/8” x 1” Bolt (59) have been attached on the
Guiding Tubes, so please separate them, then follow Step 1.2 to assemble.
s  3LIDEBOTH'UIDE4UBEINTOTHETWO2UBBER2INGSANDTHROUGHTHE(ORIZONTAL"EAMSECURE 
them with two 3/8” x 19mm Washer (66) and two 3/8” x 1” Bolts (59).
s  0LACETHENINE7EIGHT3TACKONTOTHETWO'UIDING4UBES
s  )NSTALL"LACK&IXING"USHINGINTO3ELECTOR"AR,ET&IXING0INGOTHROUGHTHEHOLEOF"LACK&IXING
Bushing (74) and the first hole of Selector Bar (32), then attach to the bottom part in the hook of Top Plate
(30).
s  4HENPUT3ELECTOR"ARINTOTHE7EIGHT3TACK!TTACHTHE"LACK7ASHERONTHEMIDDLEHOLE
of Top Plate (30).
s  #ONNECTTHE2EVOLVING0ARTWITH44UBESECURETHEMWITHONEvXv"OLTANDONE
3/8” x 1” Washer (67).