Trojan CONCEPT 200 - Assembly of the Base Frame and Back Cushion

11485-7
ASSEMBLY STEPS
STEP 02 Assembly of the Base Frame and Back Cushion
s  Join the Support Tube (1) with T-Tube (2), securing them with two 3/8” x 4” Bolts (51), two 3/8” Nuts (63) and
four 3/8” x 19mm Washers (66).
s  &ASTENTHE"ACK#USHIONTOTHE3UPPORT4UBESECUREITWITHTWOvXv"OLTSANDTWO
5/16” x 16mm Washers (68).
s  0UTTHE2IDGE4UBEONTOTOPOFTHE3UPPORT4UBE
s  4HENPUTTHE&ITTING0LATEONTOTOPOFTHE2IDGE4UBESECURINGTHEMWITHTWOvXv"OLTS
two 3/8” Nuts (63) and four 3/8” x 19mm Washers (66).
Caution:
The direction of the Bolts should be from Support Tube (1) through the Fitting Plate (27).
Incorrect direction of the bolts will affect the cables.
s  &IRMLYCONNECTTHE2IDGE4UBEANDTHETWO'UIDING4UBESSECURINGTHEMWITHTWOvXv"OLTS
and two 3/8” x 19mm Washers (66).
Note:
Two 3/8” x 1” Bolts (59) and two 3/8” x
19mm Washer (66) have been attached on
the Guiding Tube (4), so please separate
them, then follow Step 2.5 to assemble.
s  !TTACHTWO0ULLEY"RACKETSTO3UPPORT
Tube (1), secure them with two 5/16” x 2 3/4”
Bolts (53), four 5/16” x 16mm Washer (68)
and two 5/16” Nut (64).
s  !TTACH0RESS0INTO3UPPORT4UBE
with one 5/16” x 1 3/4” Bolt (57), two
5/16” x 16mm Washer (68) and one Nut
(64).
s  !TTACH+NOBANDvXv7ASHER
(67) to the Press Pin (58).