Trojan CONCEPT 200 - Assembly of the Seat Cushion and Leg Curl

11485-9
ASSEMBLY STEPS
STEP 04 Assembly of the Seat Cushion and the Leg Curl
s  &IXTHE3EAT"EAMTOTHE3UPPORT4UBESECURETHEMWITHONE&ITTING0LATEFOURvXMM 
Washers (66), two 3/8” x 2 1/2” Bolts (52) and two 3/8” Nuts (63).
s  !TTACHTHE,EG"EAMTOTHE3EAT"EAMSECURETHEMWITHTWO"RASS#OLOUR"USHINGSONEMM
End Cap (72), one 12” Nut (62), two 1/2” x 26mm Washers (65), and one 1/2” x 3” Bolt (48).
s  4HENATTACHTHE3EAT#USHIONTOTHE3EAT#USHION"EAMSECURETHEMWITHFOURvXMM
Washers (68) and four 5/16” x 3/4” Bolts (75).
s  0UTTHE2OLLER4UBEINTOTHEHOLEOF,EG"EAM
s  0OURALITTLEBITOFWATERONTOTHE2OLLERTUBEANDATTACHTWO,EGFOAMROLLERSONEITHERSIDEOFTHE
Roller Tube (33).