Trojan POWER GYM 1.0 - Assembly Steps Continued; Step 7: Arms, Bar, and Tobacco Pipe

14
POWER GYM 1.0
ASSEMBLY STEPS
STEP 7:
Attach the Press Bar (10) to the Upper
Cross Beam (9) using 1 Hex Bolt (56),
2 Washers (66) and 1 Nylon Nut (69).
Please note that 2 Small Oil Bushings
(38) have been pre-assembled onto the
Upper Cross Beam (9) as well as 4 Big Oil
Bushings (39) into the Press Bar (10).
Attach the Right Buttery Arm (12) and
the Left Buttery Arm (11) to the Press
Bar (10) using 2 Washers (66) and
2 Nylon Nuts (69).
Slide the Arm Foam Rollers (31) onto the
Right Buttery Arm (12) as well as the
Left Buttery Arm (11).
Attach the Handle Tube (18) to the Right
Buttery Arm (12) and the Left Buttery
Arm (11) using 2 Hex Bolts (61) and
2 Washers (67).
Now slide 2 Middle Empty Plugs (51)
and 2 Handle Grips (46) onto the Right
Buttery Arm (12) as well as the Left
Buttery Arm (11).
Attach the Tobacco Pipe (28) to the
Support Frame (8) using 1 Hex Bolt (63),
2 Washers and 1 Nylon Nut (71).
Slide Plum Blossom Nut (23) onto the
Tobacco Pipe (28) and secure tightly
once latched onto Press Bar (10).
Note: Each Buttery Arm is Labeled with an “L” for the Left (11)
and a “R” for the Right (12).
Left and Right is seen as if you were standing behind the unit
looking at it (i.e if facing the unit from the front the Left will now
be on your right and visa versa).
STEP 7
10
12
11
18
66
56
69
66
39
39
31
46
51
67
61
56
66
9
38
23
63
68
28
68
71
24
Step7
10
12
11
18
66
56
69
66
39
39
31
46
51
67
61
56
66
9
38
23
63
68
28
68
71
24
Step7
#19M02T008 Power Gym 1.0 UM VERSION 4.indd 14 29/05/2019 13:29