Trojan PULSE 260 - STEP 2: CONNECTING THE WIRES

12
ASSEMBLY STEPS
STEP 2: CONNECTING THE WIRES
Connect the Mid-sensor Wire 1 (49) to the Mid-sensor Wire 2 (38). Connect the Tension Wire (52) to the Tension
Wire (51).
Slide the Upright Post (26) onto the Main Frame (45) and tighten with 4 Screws (M8 x 16 mm) (32) and 4 Curved
Washers (Ø8 x Ø20 x R30 x 2 mm) (31).
STEP 2