Trojan PULSE 260 - ASSEMBLY STEPS; STEP 1: FRONT AND REAR STABILISERS ASSEMBLY

11
ASSEMBLY STEPS
1. PREPARATION
• Before assembling make sure that you will have enough space around the item.
• Use the supplied parts and hardware for the assembly.
• Before assembling, please check whether all the required parts have been supplied as per the exploded
drawing on the opposite page.
STEP 1: FRONT AND REAR STABILISERS ASSEMBLY
Attach the Front Stabiliser (54) and the Rear Stabiliser (55) on the Main Frame (45) with the Square Neck
Bolt (M8 x 73 mm) (30), Arc Washer (Ø8 x Ø20 x R30 x 2 mm) (31) and Cap Nut (M8) (28).
STEP 1