A ACCURACY
Balance tuning accuracy vs. speed
1. When the TronicalTune PLUS is switched off,
press ON three times. Press the LEFT/RIGHT
button to select CYAN A . Press ENTER.
2. Again, press the LEFT/RIGHT button to select
CYAN A . Press ENTER.
3. The LEFT/RIGHT button selects the accuracy.
More lit LEDs = higher accuracy/tuning takes a little
longer. Fewer lit LEDs = accuracy is a little lower/
faster tuning speed.
4. Press ENTER = accuracy setting stored.
D ROBOHEAD DELAY
Set a delay before the ROBOHEADS start turning after
initiating a function
1. When the TronicalTune PLUS is switched off,
press ON three times. Press the LEFT/RIGHT
button to select CYAN A . Press ENTER.
2. Press the LEFT/RIGHT button to select the CYAN D
LED. Press ENTER.
3. The LEFT/RIGHT button selects the delay. Each
unlit LED increases the delay by 0.5 seconds.
4. Press ENTER = delay setting stored.
G ROBOHEAD SPEED
Slow down the ROBOHEAD speed to accommodate guitars
whose neck relief or neck stability degrades tuning accuracy.
1. When the TronicalTune PLUS is switched off,
press ON three times. Press the LEFT/RIGHT
button to select CYAN A . Press ENTER.
2. Press the LEFT/RIGHT button to select the
CYAN G . Press ENTER.
3. Use the LEFT/RIGHT button to select the speed.
Each unlit LED decreases the speed.
4. Press ENTER = speed setting stored.
B INTERFERENCE FILTER
Reduce the interference among the strings if a wrong
ROBOHEAD is turning instead of the one that you are
plucking the string for.
1. When the TronicalTune PLUS is switched off,
press ON three times. Press the LEFT/RIGHT
button to select CYAN A . Press ENTER.
2. Press the LEFT/RIGHT button to select the
CYAN B LED. Press ENTER.
3. Use the LEFT/RIGHT button to select the degree
of filtering. Each unlit LED increases the filtering
degree to reduce interference.
4. Press ENTER = interference filter setting stored.
NOTE: Raising this setting to six lit LEDs may
increase performance but increases also the
vulnerability of the e and B strings to incorrect
tuning, even if the TronicalTune PLUS indicates
they are in tune. If this occurs, lower the Interfer-
ence Filter setting to three or four lit LEDs.
35
To Next Page
Loading...
