Trotec PAC 3500 E - Page 11

EN 10
Operating manual – local air conditioner PAC 3500 E
Setting the timer
The timer has two modes of operation:
• automatic switch-on upon expiry of a preset number of
hours.
• automatic switch-off upon expiry of a preset number of
hours.
The number of hours can be between 1 and 24 and can be
adjusted in increments of 1h.
Automatic switch-on
1. Switch off the device.
2. Press the TIMER button(17).
3. Press the UP(19) or DOWN button(23) until the desired
number of hours is displayed.
ð The number of hours flashes on the segment
display(29).
4. Wait for approx. 5seconds in order to save the setting.
ð The TIMER indication(31) appears on the display.
ð The timer setting equals the desired number of hours.
ð The hours are indicated on the segment display(29).
ð The device starts in the previously selected operating mode
after the set time has elapsed.
Notes regarding automatic switch-on:
• The settings are retained even if the power supply is
disconnected.
• Manually switching the device on disables the automatic
switch-on function.
• If you select 0hours, the timer will be off.
Automatic switch-off
ü The device is switched on.
1. Press the TIMER button(17).
2. Press the UP(19) or DOWN button(23) until the desired
number of hours is displayed.
ð The number of hours flashes on the segment
display(29).
3. Wait for approx. 5seconds in order to save the setting.
ð The display changes back to the previous indication.
ð The TIMER indication(31) appears on the display.
ð The timer setting equals the desired number of hours.
ð The device switches off after the set period of time.
Night mode
Night mode can only be activated in cooling mode. Night mode
comes with the following settings:
• After 2 hours the preset temperature is increased by 1°C.
• After another 2 hours the temperature is again increased
by 1°C, thus the preset temperature is increased by a total
of 2°C within 4 hours. Afterwards, the temperature is kept
at this value.
• The fan speed is automatically lowered to the the min.
level and cannot be changed manually.
• The swing function can be switched on via the remote
control if required.
To deactivate night mode, please proceed as follows:
1. Press the MODE button(26) until the cooling mode
indication(21,
) appears on the display.
2. Simultaneously press the TIMER(17) and FAN(18) buttons.
ð The night mode indication(20) appears on the display.
ð The fan speed is automatically adjusted to the lowest
level.
3. In order to switch the night mode off, press the TIMER(17)
and FAN(18) buttonsonce again.
ð The night mode indication(20) disappears.
ð Fan speed and temperature will return to the level that
was set before night mode was activated.
Changing the unit °C / °F
The temperature in the segment display(29) can be indicated in
°C or °F.
Please proceed as follows to change the temperature unit:
1. Simultaneously press the UP(19) and DOWN(23) buttons.
Alternatively, you can press the °C / °F button(34) on the
remote control.
ð The displayed temperature is converted to the other unit.