Trotec TCH 1 E User Manual

EN5
convector TCH 1 E
Information about the device
Device description
The convector
TCH 1 E is used to generate warm air for interior
spaces.
The device generates heat by means of an electric heating
element. The air surrounding the heating element is heated. The
heated air rises through the air outlet and thus enters the room.
The device is equipped with an integrated thermostat and so
generates a constant flow of warm air.
The device is not suitable for wall mounting.
Device depiction
6
1
4
3
5
2
No.Designation
1Air outlet
2Transport handle
3Air inlet
4Rotary switch room thermostat
5Operating control lamp
6Foot
Transport and storage
Note
If you store or transport the device improperly, the
device may be damaged.
Note the information regarding transport and storage of
the device.
Transport
To make the device easier to transport, it is fitted with a carry
handle.
Before transporting the device, observe the following:
•Switch the device off.
•Hold onto the mains plug while pulling the power cable out
of the mains socket.
•Do not use the power cable to drag the device.
•Allow the device to cool down sufficiently.
Storage
Before storing the device, proceed as follows:
•Hold onto the mains plug while pulling the power cable out
of the mains socket.
•Allow the device to cool down sufficiently.
When the device is not being used, observe the following
storage conditions:
•dry and protected from frost and heat
•in an upright position where it is protected from dust and
direct sunlight
•with a cover to protect it from invasive dust, if necessary
•Place no further devices or objects on top of the device to
prevent it from being damaged.

Trotec TCH 1 E Specifications

General

Brand	Trotec
Model	TCH 1 E
Category	Heater
Language	English