Trotec TCH 1 E User Manual

6EN
convector TCH 1 E
Assembly and installation
Scope of delivery
•1 x Convector
•2 x Foot
•2 x Fastening screw
•1x Manual
Unpacking the device
1.Open the cardboard box and take the device out.
2.Completely remove the packaging.
3.Fully unwind the power cable. Make sure that the power
cable is not damaged and that you do not damage it during
unwinding.
Assembly
Info
The device is not suitable for wall mounting.
Mounting the feet
Mount the feet before positioning the device.
1.Place the device on its side.
2.Fasten each foot with one screw.
Start-up
Info
Odours might arise upon initial start-up or after a
longer period of non-use.
When positioning the device, observe the minimum distance
from walls or other objects as described in the chapter
Technical annex.
A
B
C
C
D
•Before restarting the device, check the condition of the
power cable. If there are doubts as to the sound condition,
contact the customer service.
•Set the device up in an upright and stable position.
•Do not create tripping hazards when laying the power
cable or other electric cables, especially when positioning
the device in the middle of the room. Use cable bridges.
•Make sure that extension cables are completely unrolled.
•Make sure that no curtains or other objects interfere with
the air flow.
•Do not position the device directly below a wall socket.
•Make sure that the device cannot come into contact with
moisture or water.
Connecting the power cable
•Insert the mains plug into a properly secured mains power
socket.
•Make sure that the power cable is guided along the back
of the device. Never guide the power cable along the front
of the device!

Trotec TCH 1 E Specifications

General

Brand	Trotec
Model	TCH 1 E
Category	Heater
Language	English