10 EN
dehumidifier TTK 53 E / TTK 72 E
Memory function
The device memorizes the last selected operating mode, and in
dehumidification mode(20) also the set room humidity during
short power failures. If the timer was programmed, this setting
will not be saved.
If the device was disconnected from the mains for a longer time,
the device starts in automatic mode when it is switched back
on.
Auto stop function
If the water tank is full, not inserted correctly or the relative
room humidity has been reached, the compressor will stop
automatically. The fan keeps running.
Operation with hose attached to the condensation
connection
For continuous operation or unattended dehumidification, please
connect the supplied condensation drain hose to the device.
ü A suitable hose (diameter: 10mm) is ready for use.
ü The device is switched off.
1. Take the condensation tank out of the device.
2. Push one end of the hose onto the hose connection.
3. Refit the condensation tank into the device. In doing so,
make sure that the condensation tank is inserted correctly,
for otherwise the device cannot be switched back on.
4. Guide the other hose end to a suitable drain or sufficiently
dimensioned collection container. Please note that the
hose must not be kinked.
Remove the hose if you want to collect the condensate in the
condensation tank again. Allow the hose to dry prior to storage.
The hose can be connected in any operating mode for
continuous operation.
To Next Page
Loading...
