Gauge Appears to be Unstable
♦ Perform a stability (stat) test (20 - 1 minute counts).
Perform a drift test (5 - 4 minute counts).
♦ If the above tests pass, recheck the calibration parameters
and samples.
Gauge will not Communicate with Printer
♦ Check the cable for continuity.
♦ Check baud rates.
♦ Check cable pin-out (see page B-4).
♦ Make sure all other parameters match:
o Data bits = 8
o Stop bits = 2
o Parity = none
o Protocol = DSR/DTR
Software is not Functioning Properly
♦ Re-initialize the gauge.
♦ Contact customer service.
To Next Page
Loading...
