Troy-Bilt 12A-466M011 - User Manual

Read and understand all instruction, warning, and danger labels.
IMPORTANT: READ OPERATOR'S MANUAL AND ENGINE MANUAL THOROUGHLY AND
FOLLOW THE SAFE OPERATION PRACTICES BEFORE OPERATING .
Lea el manual de operación anexo sobre ensamblaje e inicio.
Need Help? Call 1-888-TO-HELP-U (1-888-864-3578)
Use cable
tie to secure
cables to
lower handle.
1
2
3
4
Refer to Operator’s Manual for instructions on attaching the grass catcher.
778-1166012A-466 © 2008
Blade Control Handle
(A) Lift handle
to extended
position.
(B) Tighten
star knobs.
Recoil
Starter
Star Knobs
Place ends of
lower handle
onto handle
brackets. Insert
carriage bolts
and tighten
with wing nuts.
A
B
A
C
B
D
(A) Hold blade
control handle
against upper
handle.
(B)(C) Slowly
pull starter
rope from
engine and slip
starter rope
into rope guide.
(D) Tighten
rope guide
wing knob.

Summary

Lawn Mower Assembly and Setup

Handle Attachment and Securing

Attach the lower handle to the handle brackets and tighten with wing nuts. Lift the handle to its extended position.

Control Cable Management

Secure the control cables to the lower handle using a provided cable tie for proper routing.

Starter Rope Engagement

Hold the blade control handle, slowly pull the starter rope, and route it into the rope guide.

Fueling and Starting Procedures

Fuel and Oil Filling

Fill the gas tank up to 1/2-inch from the top and the engine with the provided oil.

Engine Starting Sequence

Depress the blade control handle, then pull the starter rope with a quick, full arm stroke.

Troy-Bilt 12A-466M011 Specifications

General

Engine Displacement	140cc
Cutting Width	21 inches
Deck Material	Steel
Start Type	Recoil
Drive Type	Self-Propelled
Cutting Height	1.25 to 3.75 inches
Cutting Positions	6
Oil Capacity	15 oz
Mulching Capability	Yes
Bagging Capability	Yes
Side Discharge Capability	Yes
Engine	Briggs & Stratton
Discharge Options	Side discharge