Troy-Bilt 11A-542Q711 User Manual

IMPORTANT: READ OPERATOR'S MANUAL AND ENGINE MANUAL THOROUGHLY AND
FOLLOW THE SAFE OPERATION PRACTICES BEFORE OPERATING .
Read and understand all instruction, warning, and danger labels.
Need Help? Call 1-888-TO-HELP-U (1-888-864-3578)
Lea el manual de operación anexo sobre ensamblaje e inicio.
© 2007 11A-542Q711 778-10940C
Move hairpin clip to inside hole. Insert carriage bolt
and tighten with wing nut. Repeat on opposite side.
Secure cable to lower handle with cable tie
provided with unit.
Lift handle to extended position.
Tighten star knobs.
Starter
Rope
Blade Control Handle
Star Knobs
1
2
3
4
B
A
Hold blade control handle against upper handle.
Slowly slip starter rope into rope guide.
Tighten rope guide wing knob.
C
B
A
D
A
B
Refer to Operator’s Manual for instructions on attaching the grass catcher.

Troy-Bilt 11A-542Q711 Specifications

General

Brand	Troy-Bilt
Model	11A-542Q711
Category	Lawn Mower
Engine	Briggs & Stratton
Engine Displacement	140cc
Cutting Width	21 inches
Drive Type	Self-Propelled
Drive System	Rear-Wheel Drive
Mulch Capable	Yes
Side Discharge	Yes
Rear Bag	Yes
Grass Bag Capacity	1.9 bushels
Starter Type	Recoil
Cutting Height Adjustment Type	Dual-lever
Cutting Height	1.25-3.75 inches
Speed Settings	Variable

Summary

Lawn Mower Assembly

Handlebar Setup

Extend and secure the handlebar using star knobs and hairpin clips for proper operation.

Control Cable and Starter Rope Attachment

Attach blade control handle, route starter rope, and secure cables for safe operation.

Engine Preparation and Starting

Fueling and Oil Level Check

Fill gas tank and verify engine oil level according to instructions before starting.

Starting Procedure

Engage fuel valve, set choke, and pull starter rope to initiate engine operation.