Howto Start YourPressureWasher
To start your pressure washer for the first time, follow these
instructions step-by-step. This starting information also
appliesif you havelet the pressurewasher sit idle for at least
a day.
1. Placepressure washer near an outside water source
capableof supplying water at a flow rategreaterthan
3.3 gallons per minute and no less than 20 PSIat
pressure washer end of garden hose. DO NOTsiphon
supply water.
2. Checkthat high pressure hose is tightly connectedto
spray gun and pump. SeeAssembly section.
3. Make sure unit is in a level position.
4. Connectgarden hoseto water inlet on pressure washer
pump.
NOTICE
DONOTrun the pump without the water supply connected
and turned on. ________
I" Damageto equipmentresultingfromfailureto followthis
h instructionwill voidwarranty.
5. Turn 0I/water, point spray gun in a safe direction and
squeezetrigger to purge pump system of air and
impurities.
6. Attach nozzleextension to spray gun. Tighten by hand.
7. Engagetrigger lock (A) on spray gun trigger.
8. Whenstarting engine, position yourself as
recommendedand start engine according to
instructions given in engine operator's manual. Also
seeoperating instructions tag locatedon the pressure
washer.
WARNING
Startercord kickback (rapid retraction) can result
in bodily injury. Kickbackwill pull hand and arm
_,_< toward engine fasterthan you can let go.
Brokenbones, fractures, bruises, or sprains
could result.
• NEVERpull startercordwithoutfirst relievingspraygun
pressure.
. Whenstartingengine,pullcordslowlyuntil resistanceis feltand
thenpullrapidlyto avoidkickback.
. Aftereachstartingattempt,whereenginefailsto run,always
pointsprayguninsafedirectionandsqueezesprayguntrigger
to releasehighpressure.Engagesprayguntriggerlock.
• Firmlygraspspraygunwith bothhandswhenusinghigh
pressuresprayto avoidinjurywhenspraygunkicksback.
12 www.troybilt.¢om
To Next Page
Loading...
