Section 4: Operation
blow to Use the Battery Char er
Use batteryfloatchargerjackto keep the startingbattery
charged and ready for use. Battery charging should be done
in a dry location, such as inside a garage.
I. Plug charger into unit's "Battery Float Charger" jack,
whch is located next to starter switch (Figure 9). Plug
battery charger into a 120V ok AC wall receptacle.
2. Unplug charger from unit and wall outlet when
generator is being started and while in operation.
3. Keep this charger plugged in when generator is not in
use to prolong battery life.The charger has a built in
float equalizer and will not overcharge the battery,
even when plugged in for an extended period of time.
iMPORTANT: See "Battery Haintenance" on page 15 for
additional information.
COLD WEATHER
Under certain weather conditions (temperatures below
40°F [4°C] combined with high humidity), your generator
may experience icing of the carburetor and/or the
crankcase breather system.To reduce this problem_ you
need to perform the following:
I. Hake sure generator has dean, fresh fuel.
2. Open fuel valve (turn valve to open position).
3. Use SAE 5_Azo30oil (synthetic preferred_ see engine
manual).
4. Check oil level daily or after every eight (8) hours of
operation.
5. Maintain generator following "Maintenance Schedule"
in engine manual.
6. Shelter unit from elements.
[n an emergency, use the original shipping carton as a
temporary shelter:
7. Cut off ail carton flaps.
8. Cut out one long side of carton to expose muffler side
of unit as shown in Figure I O.
Wind
[MPORTANT: The generator must be at least 5 ft.
(152 cm) from structures having combustible wails and/or
other combustible materials. Leave at least 3 ft. (92 cm) all
around generator including overhead, for adequate cooling,
maintenance and servicing.
WARNING
DO NOT touch hot surfaces_
Allow equipment to cool before touching.
The generator must be at least 5 feet from structures having
combustible walls and/or other combustible materials.
Keep at least 3 feet of clearance on all sides of generator for
adequate cooling, maintenance and servicing_
Reflective exhaust heat may damage fuel tank causing fire.
Remove shelter when temperatures are above 40°F [4°C].
9. Cut appropriate slots to access receptacles of unit.
10. Start unit, then place carton over it.
NOTE: Remove shelter when temperatures are above
40°F {4°C].
To Next Page