ASSEMBLY
Your generator requires some assembHyand is ready for
use after it has been properHy serviced with the
recommended oiHand fuel
mfyou have any probmerns with the assernbmy of your
generator, please car the generator helpiine at
l=888=61 l =6708. if caHHingfor assistance_pHeasehave the
model revision_ and seriaHnumber from the data tag available.
See "KnowYour Generator" for data tag Hocation.
Remove Generator From Carton
H. Set carton on a rigid fiat surface with "This Side Up"
arrows pointing upward.
2. CarefuHHyopen top flaps of shipping carton.
3. Cut down corners of carton from top to bottom and
Haythat side of carton down fiat.
4. Remove aHHpacking material carton fiHHers_etc.
5. RoHHgenerator out of shipping carton.
A ach Handle
You wiHHneed two H/2"or H3 mm wrenches to attachthe
handHe.
H. Attach handHeto right side of generator frame (viewing
unit from front), as shown in Figure H,with a 60 mm
capscrew, fiat washers, nyHon washers, and Hock nut.
60ram Capscrew
li
Nut
' /Vqasher
: i Handle Bracke_
Handle Pin
I
NOTE: DO NOT overtighten. Handle must be able to
move up and down freely.
2. Raise handHe and insert handHe pin to move generator.
O
To Next Page
Loading...
