CHAPTER 2: ASSEMBLY INSTRUCTIONS
Truefitness.com / 800.426.6570 / 636.272.7100 12
TREADMILL ASSEMBLY STEPS (continued):
8. Run Calibration
a) Remove safety key
b) Press and hold INCLINE UP & INCLINE DOWN for approximately 3 seconds until a beep is heard
c) Re-insert the safety key
d) Press START to initiate incline calibration
e) Bottom A/D Count @ 600 +/- Top A/D Count @ 3400 +/-
f) After incline calibration has completed, press START to initiate speed calibration
g) At 0.5 MPH press START
h) At 12.0 MPH press START to stop (Calibration Successful)
i) Remove the safety key to exit
Power Panel Overview:
To Next Page
Loading...
