What does Fault CN07: Calibration Timeout mean on my True Treadmill?
Fault CN07 on your True Treadmill indicates a calibration timeout, which could be due to low AC line voltage. Try retrying the calibration and verifying the AC voltage at the outlet.
What to do if True TI1000 Treadmill unit resets or pauses randomly?
If your True Treadmill is randomly resetting or pausing, here are a few things you can check: * Ensure the safety e-stop key is fully engaged. * Inspect the power connection at the unit and outlet. * Verify the output voltage from the 20A outlet with a voltmeter to ensure sufficient power. * Replace the power cord if it's damaged. If an error code is displayed on the console or 'No User Present' is on the screen, further action may be needed. User weight must be over 90lbs. Verify No User Present settings in console.
What does Fault SC04: Motor Under Speed mean on my True TI1000?
Fault SC04 on your True Treadmill indicates the motor is under speed. This can be caused by high belt deck friction, high belt tension, or low line voltage. Lubricate the treadbelt and check the drive belt and walking belt tension. Also, check the AC line voltage.
What does Fault A103: Motor Controller Fault mean on my True TI1000?
Fault A103 on your True Treadmill indicates a motor controller fault. This may be due to a loose cable. Check cable connections.
What does Fault A119: Motor Controller Fault mean on my True TI1000?
Fault A119 on your True Treadmill indicates a motor controller fault. This may be due to a loose cable connection. Check cable connections.
What does Fault SP03: Belt Over Accel mean on my True Treadmill?
Fault SP03 on your True Treadmill indicates the belt is over accelerating. This can occur if the user is holding the belt back or if there's high belt deck friction. Do not try to stop the belt and lubricate the treadbelt.
What to do if my True TI1000 heart rate is displaying erratically or not displaying?
If the heart rate on your True Treadmill is displaying erratically or not at all, there could be several reasons: * Ensure the transmitter belt contacts are making good contact with your skin and are moist. * Adjust your position to be within 3 feet (1 meter) of the console. * Replace the transmitter belt if the battery is depleted. Also, another user wearing a compatible transmitter strap may be interfering if they are within 3 feet (1 meter) of the unit. Environmental interference from high voltage power lines can also cause this issue; try moving the unit or the source of interference. If the source is plugged into the same outlet, move it to another outlet.
What does Fault SC05: Motor Over Speed mean on my True TI1000?
Fault SC05 on your True Treadmill indicates the motor is over speed. This can be caused by high belt deck friction or line voltage issues. Lubricate the treadbelt and check the AC line voltage.
What does Fault A111: Motor Controller Fault mean on my True TI1000 Treadmill?
Fault A111 on your True Treadmill indicates a motor controller fault. This may be due to high belt deck friction or low line voltage. Lubricate the treadbelt and check the AC line voltage.
What does Fault CN00 mean on my True Treadmill?
If your True Treadmill shows Fault CN00: Corrupted Console Configuration, power cycle the treadmill, re-configure the console, or re-install the software/firmware. If the firmware and software versions are not compatible, re-install software/ firmware. Contact dealer or TRUE service.
To Next Page
General
