What to do if my True Treadmill displays Fault IN03?
If your True Treadmill displays Fault IN03, which indicates an incline run fault, first power cycle the treadmill, then check the cable connections and run incline calibration.
What to do if my True TC900 resets randomly?
If your True Treadmill resets or pauses randomly, check the following: - Replace the power cord if damaged. - Ensure the power cord is fully seated in the socket at both the unit and the outlet. - Make sure the safety e-stop key is fully engaged with the console. - Use a voltmeter to verify the output voltage from the 20A outlet to ensure sufficient power. If an error code is displayed on the console, further assistance is needed.
How to troubleshoot a True TC900 Treadmill with no power?
First, verify that the On/Off switch is in the ON position. Then, inspect the power connection at both the unit and the outlet to ensure the power cord is fully seated. Check the circuit breaker next to the On/Off switch to make sure it hasn't tripped; if it has, reset it. Use a voltmeter to verify that there is power at the outlet. Finally, examine the power cord for any damage and replace it if necessary.
What does Fault A101 mean on my True TC900?
Fault A101 indicates a motor controller fault. Power cycle the treadmill.
What to do if my True TC900 shows Fault CN07 Calibration Timeout?
To address the 'Fault CN07: Calibration Timeout' error on your True Treadmill, first, retry the calibration. Also, verify the AC voltage at the outlet.
What does it mean if my True Treadmill displays Fault A105?
If your True Treadmill displays Fault A105, which indicates a motor controller fault, check cable connections.
How to troubleshoot Fault A112 on a True TC900 Treadmill?
To troubleshoot Fault A112, which indicates a motor controller fault, first power cycle the treadmill, then check the cable connections.
What to do if my True TC900 shows Fault SP02 Belt Over Speed?
If your True Treadmill displays 'Fault SP02: Belt Over Speed', lubricate the treadbelt and check the AC line voltage.
How to troubleshoot Fault CN05 No Lower Control on True TC900 Treadmill?
To resolve the 'Fault CN05: No Lower Control' error on your True Treadmill, power cycle the machine, check the cable connections, and reconfigure the console.
What does Fault CN01 mean on my True Treadmill?
Fault CN01 indicates an internal fault. Try power cycling the treadmill. If that doesn't work, re-configure the console or re-install the software/firmware.
Crucial safety warnings, electrical setup, and operational precautions for the treadmill.
Specifies required clearance around the unit and identifies warning labels.
Lists parts/tools needed and outlines the main assembly process.
Visual wiring guides and specific instructions for console installation.
Identifies and describes the main parts and features of the treadmill.
Explains heart rate monitoring, chest straps, and contact pads.
Details the various pre-set workout programs available on the console.
Guides users through operating the Transcend console interface.
Covers service modes, setup, options, and diagnostics for console customization.
Instructions for cleaning the treadmill and maintaining its appearance.
Procedures for aligning, tensioning, and lubricating the running belt.
Guidance on leveling the unit and proper procedures for long-term storage.
How to contact TRUE Fitness for support and sales inquiries.
Steps to follow when receiving a damaged shipment.
Identifies common malfunctions and their corrective actions.
Details the warranty coverage, terms, and conditions for TRUE products.
Instructions for registering the product to validate the warranty.
To Next Page
General
