How do I fix Fault CN00 on my True TC900 Treadmill?
Fault CN00 indicates a corrupted console configuration. Try power cycling the treadmill. If that doesn't work, re-configure the console or re-install the software/firmware.
What does Fault CN01 mean on my True Treadmill?
Fault CN01 indicates an internal fault. Try power cycling the treadmill. If that doesn't work, re-configure the console or re-install the software/firmware.
What to do if my True TC900 displays Fault CN04?
If your treadmill displays Fault CN04, which indicates a lower board communication fault, first power cycle the machine. Then, check the cable connections.
How to resolve Fault CN05 on a True TC900?
To resolve Fault CN05, which indicates no lower control, first power cycle the treadmill. Then, check the cable connections and re-configure console.
What does error Fault CN06 mean on my True TC900 Treadmill and how can I fix it?
Fault CN06 indicates a configuration mismatch. Try power cycling the treadmill. If the issue persists, check the cable connections.
What should I do if my True TC900 Treadmill shows a Fault CN10 error?
If your True Treadmill displays Fault CN10, which indicates an E-Stop Fault, try power cycling the treadmill. Also, reinsert the safety key, and check cable connections.
How do I fix a Firmware Mismatch (Fault CN25) on my True TC900?
To fix a Firmware Mismatch (Fault CN25), first power cycle the treadmill. If that doesn't work, try reconfiguring the console or re-installing the software/firmware.
What does Fault A108 mean on my True Treadmill?
Fault A108 indicates a motor controller fault. Power cycle the treadmill and check cable connections.
What to do if my True Treadmill resets or pauses randomly?
First, ensure the safety/e-stop key is fully engaged with the console. Check the power cord to make sure it is fully seated in the outlet and at the unit. If there is still a problem, verify the output voltage from the 20A outlet with a voltmeter to ensure sufficient power. User weight must be over 90lbs. Verify No User Present settings in console. If these steps don’t resolve the issue, replace the power cord.
How to troubleshoot Fault A112 on a True TC900 Treadmill?
To troubleshoot Fault A112, which indicates a motor controller fault, first power cycle the treadmill, then check the cable connections.
Crucial safety warnings, electrical setup, and operational precautions for the treadmill.
Specifies required clearance around the unit and identifies warning labels.
Lists parts/tools needed and outlines the main assembly process.
Visual wiring guides and specific instructions for console installation.
Identifies and describes the main parts and features of the treadmill.
Explains heart rate monitoring, chest straps, and contact pads.
Details the various pre-set workout programs available on the console.
Guides users through operating the Transcend console interface.
Covers service modes, setup, options, and diagnostics for console customization.
Instructions for cleaning the treadmill and maintaining its appearance.
Procedures for aligning, tensioning, and lubricating the running belt.
Guidance on leveling the unit and proper procedures for long-term storage.
How to contact TRUE Fitness for support and sales inquiries.
Steps to follow when receiving a damaged shipment.
Identifies common malfunctions and their corrective actions.
Details the warranty coverage, terms, and conditions for TRUE products.
Instructions for registering the product to validate the warranty.
To Next Page
General
