Z8.1e Elliptical Owner’s Guide
How to Use Test Mode
TEST MODE
124
The most useful things to check:
Diagnostic LEDs: LEDs 5, 6, and 7 should all be lit.
Pedal RPM: Pedal at a moderate rate, and RPM should read
between 60 and 80.
Watts: While pedaling, this should match Targ PWR. Move the
cursor to Prog PWR using the Start key, then change this value
up and down between 50 and 200 watts. Watts should track
your changes.
TEST MODE
HOW TO USE
THESE
FUNCTIONS
To Next Page
Loading...
