SAFETY INSTRUCTIONS
n
DO NOT place objects on or against cover or framework.
n
DO NOT tie cargo to truck bed cover framework.
n
Never allow children or pets to occupy pickup box while cover is closed.
n
Cover is not airtight. Special care is required to keep cargo clean and dry.
n
Tonneau covers won’t prevent theft of contents inside truck box.
n
DO NOT stow rolled cover against cab window.
n
DO NOT attempt to drive with the cover in the partially open position!
n
A fully rolled open cover must always be secured with retainer straps.
n
DO NOT operate vehicle with objects on top of the cover.
n
CAUTION - Pinch points can cause serious personal injury.
n
CAUTION - Metal parts can get extremely hot if left in bright sun and or heat.
TROUBLESHOOTING TIPS
COVER ASSEMBLY WILL NOT ATTACH TO SIDE RAILS DURING INSTALLATION
n
Check side rails to make sure they are level.
n
The rolled-up cover is heavy which may be exing the rails downward. Push front of rail up slightly to allow the
screw head to fall in the slot and the header guide to slide freely into the secured location.
n
If rear header doesn’t latch correctly check side rail installation.
HEADER WILL NOT LATCH
n
Check side rails to make sure they are level.
n
Make sure the rear header seal is not caught between side rail & rear header.
n
If rear header doesn’t latch correctly check side rail installation.
n
Check to make sure side rails are both equally spaced front to rear.
n
Make sure both latches are functioning properly. Clean any debris that may be impeding latches.
COVER CARE AND MAINTENANCE
n
Clean with mild automotive soap and water. Do not use vinyl conditioners (i.e. Armor All®) because they will shrink the vinyl. The cover
can be cleaned in a car wash. Never use vinyl conditioners that contain silicon, petroleum, or citrus based products on your truck bed
cover as they may crack and shrink the vinyl top surface.
n
It is recommended that you periodically check that the cover is securely attached to your truck bed. Inspect the clamps
and front header guide slides to ensure they were properly installed and have not come loose during operation.
n
It is recommended that you periodically inspect and service the rear latch closures. Clean away any excess dirt or grime
and lubricate with silicone spray.
n
Covers that are used frequently or are subject to vibrations and impacts from rough roadways may require adjustment.
TruXedo Inc. • 2209 Kellen Gross Drive Yankton, SD 57078 • 877-878-9336 • truxedo.com ©TruXedo Inc., 2022
Part# 1118240 Rev. D 8.18.22
To Next Page
Loading...
