EasyManuals Logo

TSC M23 Programming Manual

TSC M23
252 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #18 background imageLoading...
Page #18 background image
TSC AUTO ID Technology Co., Ltd. 6 Copyright 2013 All Rights Reserved.
AUTODETECT
Description
This command feeds the paper through the gap/black mark sensor in an effort to determine the paper
and gap/black mark sizes, respectively. This command references the users approximate
measurements. If the measurements conflict with the actual size, the AUTODETECT command will not
work properly. This calibration method can be applied to the labels with pre-printed logos or texts.
Syntax
AUTODETECT [x,y]
Parameter
Description
x
Paper length (in dots)
y
Gap length (in dots)
Note:
If the x, y parameters are ignored then the printer will calibrate and determine the paper
length and gap/black mark size automatically.
When using this command, the printer will detect the label by the proper sensor type so
please dont set the command GAP or BLINE in your program.
It is supported in firmware V6.86 EZ or later.
See Also
GAP, SIZE, GAPDETECT, BLINEDETECT

Table of Contents

Other manuals for TSC M23

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the TSC M23 and is the answer not in the manual?

TSC M23 Specifications

General IconGeneral
BrandTSC
ModelM23
CategoryPrinter
LanguageEnglish

Related product manuals