3.16 Cutter Module Installation (Option)
1. Refer to section 3.1 to remove the lower front panel.
2. Remove the lower fixed bar by disengage the 2 screws (fastened by 7.5 kg±15% kg-cm).
3. Plug the cutter cable connector into the cutter/peel-off cable socket. Put 2 locating protrusions into locating holes as indicated.
4. Fasten the 2 black fixing bolts and 2 screws (7.5 kg±15% kg-cm) to fix the cutter module then closed the plate.
5. Fasten the 1 limit screw (7.5 kg±15% kg-cm) and the rest 2 screws (7.5 kg±15% kg-cm) on cutter module plate as indicated.
To Next Page
Loading...
