Peel-off Sensor Module Installation
1. Refer to section 3.1 to remove the lower front panel.
2. Remove the 2 screws and uninstall the lower fixed bar (fastened by 7.5 kg±15% kg-cm).
3. Install the peeler roller on the slot, then fix the screw (7.5 kg±15% kg-cm) as indicated.
Note: The screw must close to the roller ring to fix it and preventing roller loosen when peeling the label.
4. Disconnect the power cord than plug the peel-off sensor module cable connector into the cutter/peel-off cable socket.
Note: The cable can be fixed by stick the tape on electronic side.
To Next Page
Loading...
