- 30 -
Wrinkle
Example
If the wrinkle on the label starts from the lower
left side to upper right side, please do following
adjustment.
1. Clockwise direction adjust
adjustment knob to “2” or “1” position. Then
check if wrinkle is gone.
2. Decrease the right side print head pressure
adjustment knob setting 1 level per each
adjustment then print the label again to
check if wrinkle is gone.
3. If the right side print head adjustment knob
setting has been set to index 1 (the lowest
pressure index), please increase the left
side print head pressure.
4. If the left side print head adjustment knob
setting has been set to 5 (the highest
pressure index) the wrinkle can’t be avoid,
please rotate the both knobs back to setting
1 then rotate the Z-axis mechanism
adjustment knob clockwise for a few
degrees and print again for fine tune the
print head pressure distribution.
Note for step 4:
*Factory default setting, the Z-axis knob is
rotated counter clockwise to the end of
thread.
*Turn the Z-axis mechanism adjustment knob
clockwise until you feel the knob touch the
mechanism for the first adjustment.
* If the wrinkle is still there, please turn the Z-
axis mechanism adjustment knob clockwise
about 1/4 circle each time for adjustment
* If the winkled direction is change from “/” to “\”
by adjusting the Z-axis mechanism adjustment
knob, please turn the Z axis mechanism
adjustment knob counter clockwise
wrinkle.
If the wrinkle on the label starts from the lower
right side to upper left side, please do following
adjustment.
1. Counter clockwise adjust the ribbon tension
adjustment knob to “4” or “5” position. Then
check if wrinkle is gone.
2. Decrease the left side print head pressure
adjustment knob setting 1 level per each
adjustment then print the label again to check if
wrinkle is gone.
3. If the left side print head adjustment knob level
has been set to index 1 (the lowest index),
please increase the right side print head
pressure.
To Next Page
Loading...
Need help?
General
