- 35 -
Slew Speed
Use this item to set feed speed. The each increase or
decrease is 1 ips.
203dpi: 6
300dpi: 4
Back Speed
Use this item to set back speed. The each increase or
decrease is 1 ips.
2
Density
Use this option to setup printing darkness. The available
setting is from 0 to 15, and the step is 1. You may need to
adjust your density based on selected media.
8
Direction
The direction setting value is either 1 or 0. Use this item to
setup the printout direction.
0
Print mode
This item is used to set the print mode as below,
Next label top of form is aligned to the print
head burn line location. (Tear Off Mode)
Once image is printed completely, label
gap/black mark will be fed to the tear plate
location for tear away.
Enable the label peel off mode.
Enable the label cutter mode.
Cut the label once at the end of the printing job.
Enable the label rewind mode
The printer prints a label when it receives a
signal from the applicator.
Batch Mode
Offset
This item is used to fine tune media stop location. Available
setting value is from “+” to “-” or “0” to “9”.
0 dot
This item is used to fine tune print position. Available setting
value is from “+” to “-” or “0” to “9”.
This item is used to set the origin of printer coordinate system
horizontally and vertically. Available setting value is from “0” to
Reference Y 0 dot
Use this item to set the code page of international character set.
Use this option to set the country code.
Note: If printing from enclosed software/driver, the software/driver will send out the
commands, which will overwrite the settings set from the panel.
FEED
To Next Page
Loading...
Need help?
General
