TSC Printronix MB240 Series User Manual

41
5.6 Setting Post-Print Action
When the printer is equipped with other option kits, ex: cutter, peeler, rewinder, please select the mode after finishing the calibration.
Follow below procedure to set the post action for the printing:
Refer to section 5.1. Connect the printer with TSC Console > Double click the printer > The Printer Configuration Page will pop up >
Click Get to load information > Go to Common Tab > Find Post-Print Action > Select the mode depends on users’ application > Click
Set.

TSC Printronix MB240 Series Specifications

General

Type	Industrial Barcode Printer
Resolution	203 dpi (8 dots/mm)
Media Type	Direct Thermal, Thermal Transfer
Communication Interface	USB, Serial, Ethernet
Interface	USB 2.0, RS-232, Parallel, Ethernet 10/100
Supported Barcodes	Code 39, Code 128, UPC-A, UPC-E, EAN-8, EAN-13, Interleaved 2 of 5, Codabar, PDF417, QR Code, Data Matrix
Scanning Method	Thermal Transfer/Direct Thermal
Operating Temperature	41°F to 104°F (5°C to 40°C)
Storage Temperature	-40°F to 140°F (-40°C to 60°C)