TSC Printronix MB240 Series User Manual

62
6.9.1 Configuring the Printer and Setting Options for the Linerless Media
• Models shipped with the linerless cutter module do not require any configuration. You can start using the printer after installing
the linerless cutter module onto the printer.
• For models shipped with the linerless tear-off module, follow the steps below to configure the printer after loading the linerless
media into the printer.
1. Select Setting. Make sure the Command Set is set to
TSPL. Select Print Mode and set the print mode to Peeler
Mode.
2. Select Sensor > Auto Calibration > Continuous. When
the calibration is finished, you can start using the printer.
The following paragraph describes the setting options that help optimize the print quality when using the linerless media. The setting
options will automatically appear in the Favorites folder after installing the linerless cutter/tear-off module onto the printer.

TSC Printronix MB240 Series Specifications

General

Brand	TSC
Model	Printronix MB240 Series
Category	Barcode Reader
Language	English