Sets how often the printer should be cleaned after printing with the linerless media.
Warning: Turns on/off notification that reminds users to clean the printer if the set mileage is fulfilled.
Default setting: ON.
Interval: Schedules printer maintenance after printing with the linerless media. When the set amount
of mileage is fulfilled, the warning icon that reminds users to clean the printer will appear on the display
panel. Default setting: 1 km.
Clean Cutter Blade: Lifts up to expose the cutter blade. Select this item to lift up the cutter blade if you
need to clean the blade.
NOTE: Clean Cutter Blade will be displayed in the menu after installing the cutter module on the
printer. For how to clean the linerless cutter blade, please refer to 8.2 Cleaning the Printer after
Linerless Printing for more information.
CAUTION: To avoid the risk of personal injury, keep your hands away from the cutter gate when
selecting Clean Cutter Blade. Selecting this item will lift up the blade.
Reset Counter: Resets the mileage count after cleaning the printer.
To Next Page
Loading...
Need help?
General
