1. Open the right side cover of the printer.
2. Using the front display to calibrate the media.
3. Enter the Menu to set peeler mode.
(Menu SettingPrint Mode Peeler Mode)
4. Open print head release lever to pull approximately 650mm of label through the
front of the printer and remove some labels.
5. Open the peeler off cover. Feed the liner between peel-off roller and platen roller.
6. Wrap the label onto the internal rewind spindle and wind the spindle counter-
clockwise until the liner is properly stretched.
7. Close the peeler off cover and the print head mechanism.
8. Peeling will automatically start. Press the FEED button to test.
Please calibrate the gap/black mark sensor before loading media in peel-off
mode to avoid paper jam. Please calibrate the gap/black mark sensor when
changing media.
To Next Page
Loading...
