TSC PRINTRONIX ML340P User Manual

59
 Sensor sensitivity is not set properly.
 The media sensor is covered with dust.
 Calibrate the sensor by Auto Gap or Manual Gap options.
 Clear the GAP/Black mark sensor by blower.
Wrinkle Problem
 Printhead pressure is incorrect.
 Ribbon installation is incorrect.
 Media installation is incorrect.
 Print density is incorrect.
 Media feeding is incorrect.
 Please refer to the chapter 4.
 Please set the suitable density to have good print quality.
 Make sure the label guide touch the edge of the media
guide.
RTC time is incorrect when reboot
the printer
 The battery has run down.
 Check if there is a battery on the main board.
The left side printout position is
incorrect
 Wrong label size setup.
 The parameter Shift X in LCD menu is
incorrect.
 Set the correct label size.
 Press [Menu] [Setting]  [Shift X] to fine tune the
parameter of Shift X.
The printing position of small label
is incorrect
 Media sensor sensitivity is not set properly.
 Label size is incorrect.
 The parameter Shift Y in the LCD menu is
incorrect.
 The vertical offset setting in the driver is
incorrect.
 Calibrate the sensor sensitivity again.
 Set the correct label size and gap size.
 Press [Menu] [Setting]  [Shift Y]  to fine tune the
parameter of Shift Y.
 Set the vertical offset in the driver if you’re using
BarTender.

TSC PRINTRONIX ML340P Specifications

General

Brand	TSC
Model	PRINTRONIX ML340P
Category	Printer
Language	English