3.2 Loading the Label Stock
1. Insert a 1” label spindle into a paper roll ( * If your paper core is 1 inch, remove the 1.5” core adapter from the fixed tab. If label
width is 4 inch wide, two fixing tabs are not required.)
2. Open the printer’s top cover by releasing the green top cover open levers located on both sides.
3. Place a roll of paper into internal paper roll mount.
4. Feed the paper, printing side face up, through the label guides and place the label over the platen.
5. Adjust the black center-biased label guides in or out by turning adjustment knob so they are slightly touch the edges of the label
backing.
6. Close the printer top slowly and securely.
Printing Side
1.5” Core
To Next Page
Loading...
