TSC PRINTRONIX TDP-247 Series - Page 14

10
6. Hold the lower cover and lift up the top cover
opening levers to separate the lower inner cover
from the lower cover.
7. Thread the harness red connector through the cable
hole at the front side of lower inner cover. Plug the
red peel off module harness connector at the
location JP17 (TDP-245) / JP19 (TDP-245
Plus/TDP-247/TDP-345) on the main board. Place
lower inner cover to the lower cover. Install the peel-
off module to the lower inner cover slot.
8. Gently push peel-off panel to lock to the lower inner
cover.
9. Reassemble parts in reverse procedures after
installing the module.
Install one side first
and install another
side