TSC PRINTRONIX TDP-247 Series - Page 17

13
TDP-245 Model
TDP-245 Plus/TDP-247/TDP-345 Model
7. Plug in the Cutter Driver IC at U14(TDP-245) /
U30(TDP-245 Plus/TDP-247/TDP-345) socket on
the main board.
8. Hold the lower cover and lift up the lower inner
cover.
9. Arrange the cutter module harness through the
bezel.
10. Connect the cutter module harness to the 4-pin
socket on printer PCB.
11. Reassemble lower inner cover back to lower cover.
12. Install cutter module into the niche of the printer.
13. Close the top cover.