TSI Instruments CERTIFIER FA - Figure 1. the Certifier FA Test System

1: Introduction
2
Controller
module
Low Flow
module
High Flow
module
Oxygen
sensor
Figure 1. The Certifier
®
FA Test System
WARNING
 To avoid the risk of explosion, do not use in the presence of
flammable anesthetic gases.
 Only qualified and trained service technicians are authorized to
service the Certifier
®
FA Test System. Use only factory-approved
parts and procedures to service the device.
CAUTION
 To avoid inaccurate test readings, do not obstruct tubing or inlet
or exhaust ports, and always use dry gas.
 To avoid damage to the Certifier
®
FA Test System components,
always use bacteria filters upstream of the flow modules, and
always cap flow module ports when not in use.
 TSI flowmeters are not medical devices under FDA 510(k) and in
no situation should be used for human measurements.