TSI Instruments CERTIFIER FA - 2 Setup; Figure 3. Connecting the Controller Module to a Flow Module

7
2 Setup
Follow these steps to set up the Certifier
®
FA Test System:
CAUTION
To avoid damage to the Certifier
®
FA Test System components,
always use bacteria filters upstream of the flow modules, and always
cap flow module ports when not in use.
1. Connect the controller module to a flow module (Figure 3).
To remove the cable, pull its locking connector (not the cable)
from the controller module.
Controller
module
Flow
module
Figure 3. Connecting the Controller Module to a Flow Module