Preparation
Construction of the device may be changed by the manufacturer in order
to improve operation.
Option 1.
Option 2.
1. Apply saddles to the contact surfaces of the
G-Clamp(14E) from the spare parts package.
2. Stick to the back side of the body 5 bumpers
(14F) from the spare parts package.
3. Attach body to the table with G-Clamp.
1. Stick 5 bumpers (14F) from the spare parts
package. on the back of the stand.
2. Place the sharpener body into the hollow part
of the stand. Attach by tightening the thumb-
screws.
8
To Next Page
Loading...
