TST TM-510 - Page 13

• Connue to set the high and low pressures for each axle.
• When you get to the Trailer Secon of the display,
all the res will ash. You can now set all the trailer
axle high and low pressures as one group. Set the
high-pressure alarm rst, than press and release
t h e “ M O D E ” b u  o n a n d s e t t h e l o w - p r e s s u r e a l a r m .
• Press and release the “MODE” buon once again. The
Temperature icon appears and the default temperature
seng of 158° will display. Typically, do not change this
seng unless you have a special circumstance.
• Finally…IMPORTANT…Push and release the “SET” buon
to save all your parameter sengs in the monitor.
High Pressure-Trailer Low Pressure-Trailer
TST-Doc-510 Manual-(A)
Truck System Technologies - 4250 Keith Bridge Road, Suite 200, Cumming, GA 30041
info@tsttruck.com
13