3
INDEX
CERTIFICATIONS
I FG-SYS DIGITAL UNIT INSTALLATION
1. Fixing the Digital Unit
2. Electrical Characteristics
3. Electrical Connection of the FG-SYS
3.1. Connection of the FG-SYS Digital Unit to the Earth
3.2. Connection of the Power Supply Cable
3.3. Connection of the Leader Cable FG-CLC
3.4. Connection of the Relays
3.5. Connection of the Serial Cable
3.6. Closing of the FG-SYS Digital Unit (wall mounted version) metal enclosure
II SENSE CABLE AND ACCESSORIES INSTALLATION
1. Sense Cable Installation
1.1. Hold down clips and cold adhesive with CFC-100
1.2. Installing Sense Cables FG-EC, FG-AC and FG-ECX
1.3. Installing Hydrocarbon and Solvents Sense Cable FG-OD
1.4. Identification or Labeling with ES-EC Tags
2. Jumper Cable FG-NC Installation
3. Accessories Installation
3.1. FG-DTCS Addressable Box
3.2. FG-DCTL– “Cut-to-Length” Addressable Box
3.3. FG-DTC, TTK Bus Diversion
3.4. FG-DOD, OD Bus Diversion
3.5. End Termination Plug
III STARTUP OF THE SYSTEM
1. Powering of the FG-SYS Digital Unit
2. Standby Mode
3. Communication Configuration
IV TEST PROCEDURES
1. Function Test
2. Test of Leaks
3. Test of Cable Break
4. Drawing FG-MAP
V MAINTENANCE – FAULTS FINDING
1. Checking the System
2. Maintenance of the System
2.1. Replacement of a sense cable
2.2. Precaution for use and storage
2.3. Addition of sense cables on an existing circuit
2.4. Addition of a new circuit of sense cables
3. Trouble Shooting Guide
APPENDIX
Connection of Digital Unit FG-SYS E or FG-SYS F (Wall or Rack version)
To Next Page
Loading...
